Publicidad
Idiomas disponibles
Idiomas disponibles
8. Ready meals should be taken out of the water with tongs or other kitchen
utensils. Do not put your hands in hot water!
Time and temperature settings
1. To set the temperature, press the "SET" button, the symbol "SET" and the
last set temperature will flash on the left side of the display. Use the up and
down buttons to set the preferred value. To save the entered setting, press
the "SET" button and go to the time settings or wait 5 seconds (not pressing
any button on the panel!).
2. To set the cooking time, press the "SET" button until the
icon and the
first two digits on the right side of the display start flashing. Use the up and
down buttons to set the time. Then press the "SET" button until two
consecutive digits start flashing - set the minutes in the same way. Press the
"SET" button to save the settings or wait 5 seconds (not pressing any button
on the panel!).
3. Holding down the up and down buttons increases the speed of changing the
parameter.
Standby mode/Device shutdown
1. At the end of the countdown, the device will beep 5 times, then it will beep
every minute until the user presses any button on the control panel. The
device will go into standby mode, i.e. the heater and the water pump will stop
working. The display backlight will flash and the time will be "00:00".
2. The device remains in standby mode for up to 4 hours. If during this time
the user doesn't press any button on the control panel, the circulator will
automatically turn off.
3. The device can also be turned off manually with the On/Off button. The
display will go blank and the device will beep.
Publicidad
