Safety Instructions - cecotec BIGDRY 7000 Manual De Instrucciones

SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the appliance.
Keep this instruction manual for future reference or new users.
Make sure that the mains voltage matches the voltage stated
on the rating label of the appliance and that the wall outlet is
grounded.
This unit is designed to be used with R-290 (propane) gas only.
The refrigerant loop is sealed. Only a qualified technician
should attempt to service it.
Check the power cord regularly for visible damage. If the cord is
damaged, it must be replaced by the official Technical Support
Service of Cecotec, in order to avoid any type of danger.
To avoid electric shocks, do not clean with or allow to get inside
the product: Water, liquid or any flammable substance.
Do not immerse the cord, plug, or any non-removable part
of the appliance in water or any other liquid, nor expose the
electrical connections to water. Make sure your hands are dry
before handling the plug or switching on the appliance. Prevent
water from spilling onto the unit.
Do not tilt or turn over the unit.
Switch off the device immediately in the event of defects or
malfunctions and before repairing it. Unplug the power cord
when cleaning or when not in use.
Do not use the device if its cord or any other part is damaged.
In this case, contact the official Technical Support Service of
Cecotec.
Do not spray insecticide, perfume or other flammable
substances around the product. Do not operate the device with
products with odours.
Do not install the device near to heat-generating appliances or
flammable and dangerous materials.
8 BIGDRY 7000 MASTER CONNECTED
This product does not replace normal ventilation products.
Make sure the product is used and kept in well-ventilated areas.
During operation, leave at least a 30-cm space on the back and
sides of the product.
The device must be placed so that the plug is accessible.
The appliance shall be installed in accordance with local
national wire and gas regulations.
Operate the device in a temperature range between 5 ºC and
35 ºC. Operating it out of this range could cause the device not
to operate properly.
Ensure the filter and the product's cover are properly installed
before operating it.
Place the device on a stable and level surface.
Do not sit or stand on the device.
Disconnect the device if it is not going to be used for a long
time.
Make sure the tank is emptied after each use to ensure proper
operation.
Do not unplug by pulling on the power cord.
Do not use an extension cord or an adapter plug.
Do not put objects on the unit.
Do not climb or sit on the unit.
Do not discharge the refrigerant into the atmosphere.
Do not operate the device in closed areas such as inside closets.
Do not use outdoors.
Do not insert fingers or other objects in the air inlet or outlet to
prevent injuries and product damage.
Do not touch the air inlet or the aluminum fins of the unit.
Do not twist, bend, strain, or damage the power cord in any
way. Protect it from sharp edges and heat sources. Do not let
it touch hot surfaces. Do not let the cord hang over the edge of
the surface.
BIGDRY 7000 MASTER CONNECTED 9