Heltun HE-HLS01 Guia De Inicio Rapido página 12

DISASSEMBLY
1. ENSURE POWER IS SWITCHED OFF at the main circuit breaker AND THE LED
INDICATOR IS OFF.
2.
Disconnect the wires by inserting a small Phillips-head screwdriver into the slot
beneath each wire and unscrewing to release.
Z-WAVE NETWORK
The HE-HLS01 may be operated in any Z-Wave network with other Z-Wave certi ed devices
from other manufacturers. The HELTUN HE-HLS01 will act as a 'repeater' for other devices
regardless of manufacturer or brand to increase the reliability of the overall network.
Security
S0, S2 unauthorized, and S2 authorized Inclusion Modes are supported. If you use the S2
authorized Inclusion Mode the security key should be used during the inclusion process.
The Security Key is printed on a card located with this quick start guide and also on the
device (see Figures 4 & 5).
Note: Be sure to save this key. Without the key, it is impossible to perform an Inclusion in
S2 authorized mode.
SmartStart
SmartStart-enabled products can be added to a Z-Wave network by scanning the Z-Wave
QR Code shown on the product with gateways/controllers that provide for SmartStart
inclusion. In this case, no further action will be required and the SmartStart product will be
added automatically within ten minutes of being turned on in the vicinity of a network.
To add the HE-HLS01 to the Z-Wave network using SmartStart:
1. Set the main controller in Security S2 Authenticated "Add Mode".
2.
Input the High Load Switch DSK to the controller's Node Provisioning List (or scan the
QR code).
3. Power on the device.
4. Wait for the adding process to complete.
5. Successful adding will be con rmed by a message on the Z-Wave controller and the
LED indicator on HE-HLS01 will turn green for three seconds then continue to slowly
blink green continuously while the device is Powered On.
Note: The device security code (DSK) and SmartStart QR code are printed on the rear and
front of the HE-HLS01 plus on the additional Security Card included in the packaging (see
Figures 4 & 5).
Note: During SmartStart inclusion the device will be included to the gateway as a binary
switch. If you want to use the device as a thermostat, use manual inclusion process.