WIFI CONTROL MODULE FOR ROLLER SHUTTERS AND BLINDS
C - INSTALLATION
4 - PAIRING THE MODULE
As soon as it is switched on, the module will be
in pairing mode by default. The indicator light will
then fl ash until the pairing procedure is completed.
IMPORTANT: The network compatibility of this
device is 2.4 GHz WiFi - WPA/WPA2. Not compatible
with 5 GHz WiFi or with WEP encryption. Please
check the WiFi settings of your router or contact
your Internet service provider if you experience
connection diffi culties.
To start pairing, press ADD A PRODUCT. Ensure
that your phone is connected to the 2.4 GHz WiFi
network of your router
At Home
TABLEAU DE BORD
TA
TA
T BLEAU DE BORD
Aucun appareil connecté.
AJOUTER UN PRODUIT
Select the product that you wish to pair and select
the connected module ACCESS.
8
EN
Select your 2.4GHz WiFi network, enter your network
password and press NEXT.
12:30
Please wait while the pairing procedure takes
place. This stage can last several minutes.
In the event of failure, check the WiFi range of the
module. To do this, connect it close to your WiFi
network. Check your network password and check
that you are on 2.4GHz WiFi. Then perform a reset
and restart the procedure.
Your Thomson ACCESS module has been successfully
paired. You can set a name and press FINISH. The
module indicator light goes out after pairing.
Ajouter un produit
Module de chauffage CALI‐O
Pour radiateur on/off
Module de chauffage CALI‐P
Pour radiateur fil pilote
Module de chauffage CALI‐B
Pour chaudière
Prise connectée PLUG‐I
Pour intérieur
Prise connectée PLUG‐O
Pour extérieur
Module connecté DIANE‐2
Pour éclairage deux voies
Module connecté GUARDIAN
Pour portes de garage et portails
Module connecté ACCESS
Pour volets roulants et stores
Android Version
12:30
IOS Version