Dmx Linking; Signal Connection - Chauvet Professional COLOR STRIKE M Guía De Referencia Rápida

RF Exposure Warning for North America and Australia
Warning! This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Contact
Outside the U.S., U.K., Ireland, Benelux, France, Germany, or Mexico, contact your distributor to request support or
return a product. Refer to
What is Included
• Color STRIKE M
• Seetronic Powerkon IP65 power cord
AC Power
This product has an auto-ranging power supply that can work with an input voltage range of 100–240 VAC, 50/60 Hz.
AC Plug
Connection
AC Live
AC Neutral
AC Ground
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.

DMX Linking

The Color STRIKE M will work with a DMX controller using a 5-pin DMX serial connection. A DMX Primer is available
from www.chauvetprofessional.com.
DMX Connection
The Color STRIKE M uses a 5-pin DMX data connection for its 6 control personalities: 8CH, 11CH, 13CH, 24CH, 30CH,
74CH, and 97CH. See the User Manual for information about connecting and configuring the product for DMX operation.
Master/Slave Connection
The Color STRIKE M uses the DMX data connection for its master/slave mode. See the User Manual for information
about how to connect and configure the product for master/slave operation.

Signal Connection

The Color STRIKE M can link to controller software using an Ethernet connection. If using other Art-Net™- or sACN-
compatible products with the Color STRIKE M, each product can be controlled individually on a single network. See the
User Manual for information about how to connect and configure the product for these signals.
Art-Net Connection
™
Art-Net™ is an Ethernet protocol that uses TCP/IP, which transfers a large amount of DMX512 data using an Amphenol
XLR Net RJ45 connection over a large network. An Art-Net™ protocol document is available from
www.chauvetprofessional.com. Chauvet Professional recommends using unicast Art-Net™ for best results.
Art-Net™ designed by and copyright Artistic Licence Holdings Ltd.
sACN Connection
Also known as ANSI E1.31, Streaming-ACN is an Ethernet protocol that uses the layering and formatting of Architecture
for Control Networks to transport DMX512 data over IP or any other ACN-compatible network.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. Check the DMX controller's User Manual or with the manufacturer as not all DMX controllers
have this capability. The Color STRIKE M supports RDM protocol that allows feedback to make changes to menu map
options. Download the User Manual from
Color STRIKE M QRG Rev. 8
QUICK REFERENCE GUIDE
Contact Us at the end of this QRG for contact information.
Wire (U.S.)
Black
White
Green/Yellow
www.chauvetprofessional.com
• Omega bracket
• Quick Reference Guide
Wire (Europe)
Brown
Blue
Green/Yellow
for more details.
EN
Screw Color
Yellow/Brass
Silver
Green
2