Publicidad
Idiomas disponibles
Idiomas disponibles
G
Depress the throttle safety release and throttle control lever to operate tool. NOTE:
The spindle revolves at full speed when throttle control lever is fully depressed. As
thumb is raised the self releasing throttle closes, slowing down the spindle and
allowing the operator to choose the best speed and power for the job. When the
throttle lever is completely released it cannot be depressed again until the safety
release is disengaged.
G
Release throttle control lever to stop tool.
G
Always disconnect air supply when changing collets.
G
When job is complete, turn the air compressor off and store as described in the air
compressor operator manual.
Lubrication
Air tools require lubrication throughout the life of the tool. The air motor and bearing use
compressed air to power the tool. Because moisture in compressed air will rust the air
motor, you must lubricate the motor daily. An inline oiler is
recommended.
To lubricate the air motor manually:
G
Disconnect the tool from the air supply holding it so the air inlet faces up.
G
Depress the throttle safety release and throttle control lever and
place one to two drops of air tool oil in the air inlet Depressing the
throttle control lever helps circulate oil in the motor. NOTE: Use
SAE #10 weight oil if air tool oil is not available.
G
Connect the tool to an air source, cover the exhaust end with a
towel and run for a few seconds.
D22713
MAINTENANCE
Any excess oil in the motor is immediately
expelled from the exhaust port. Always direct exhaust port
away from people or objects.
Failure to lubricate the tool at the air inlet will void your
warranty.
6- ENG
Publicidad
