Publicidad
Idiomas disponibles
Idiomas disponibles
A dot is flashing on display, emits a
beep and unit is off
The display shows "cf"
The display shows "Ht" or "It" blinking The internal temperature is too high.
The display shows "Fi"
The tip-over switch has been activated Make sure the appliance is standing up-
The filter has reached the pre-defined
number of hours
The air intake or air outlet is obstructed
The fan motor does not work
12
right on a flat surface. If the appliance
doesn't work please contact Customer
Service
Replace the filter and reset the alarm.
To reset the CF alarm, in rapid
succession insert the plug and touch
and hold the ON/STANDBY (A) button
on the unit for at least 10 seconds until
you hear a long beep.
Check the appliance is correctly
positioned respecting the minimum
distances from the wall, or objects, as
indicated in the instruction manual, if
not, position the appliance correctly
Remove the obstruction
Disconnect the plug from the outlet
and let the appliance cool down. After
few minutes plug the appliance again.
If the appliance doesn't work please
contact Customer Service
Disconnect the plug from the outlet.
After few minutes plug the appliance
again. If the problem persists please
contact Customer Service
Publicidad
