Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 6
1. Glass
2.Silicon Seal
3.Tray
4.Connection Element
2.2.2.
Installation of the range
The range is equipped with a seal to prevent the liquids through the
cavities into the cabinet. In order to place this seal, adhere the seal as
shown in the figures above. Turn the range upside down and remove the
protective tape of the rubber seal and adhere it to the range; both ends of
the seal should meet each other. Install the mounting sheets as shown in
figure 5 by help of screw. And place the range in the opening on the
counter.
Figure 7 shows the size to which the counter will be cut for installation of
the range. Place the prepared range into the counter cut to these sizes. If
you will use the range on the built-in oven, observe the figures 9 and 10
for proper air circulation between the oven and range.
Start to use after you remove the protective film on Inox surface.
1
2
3
4
Figure 7
Figure 8
5
6
7
8
9
5. Upper Tray
6.Silicon Seal
7.Counter Surface
8.Connection Clips
9.Screw
9
Figure
EN
8
Publicidad
