Quick Start Guide; Indication Summary - Bellman & Symfon BE1284 Manual De Instrucciones

Quick start guide

Make sure to select a location complying with the advice in Location and positioning.
1 Lift off the mounting bracket and carefully place your thumb over the batteries and
remove the pull tab to power the smoke alarm.
2 Taking care to avoid any electrical wiring, fix the mounting bracket to the ceiling or
wall using the supplied screws and plugs. Mount it at least 305 mm (12") from walls
and obstructions, ideally centrally in the room or area.
3 Fit the alarm to the bracket by turning it clockwise until it snaps into place.
1
Testing the connection
1 Press the test/silence button and release
it when the alarm sounds. The alarm
transmits a radio signal to the receiver.
2 The red Visit LED on the receiver lights up
to show that the signal was received. In
addition, it starts to sound, flash or vibrate
depending on the receiver.
Note: The alarm will stop sounding after the
button is released and the Visit receiver will
time out in less than a minute.
5
2 3
1 2

Indication summary

Normal operation Action
Power up Pull battery tab
Standby
Sensing fire
Silence alarm Press test button
Fault mode Action
Low battery
Faulty smoke sensor
Faulty heat sensor
End of life
Silence end of life Press test button
for up to 30 days
Contaminated
chamber
Test mode Action
Test smoke alarm Press test button
Alarm memory Action
24 h memory*
Memory reset* Press & hold button
Note: During test and in case of fire, the red LED on the Visit receiver lights up and it
starts to sound, flash or vibrate depending on the receiver.
* See Alarm memory on page 27.
LED Sounder
1 red + 1 yellow blink Off
Off Off
Red + green Full sound
1 red blink / 8 s Off for 10 mins
Alarm LED Sounder
1 yellow blink / 48 s 1 beep / 48 s
2 yellow blinks / 48 s 2 beeps / 48 s
2 yellow blinks / 48 s 2 beeps / 48 s
3 yellow blinks / 48 s 3 beeps / 48 s
Off for 72 h Off for 72 h
4 yellow blinks / 48 s Off
Alarm LED Sounder
Red + green Full sound
Alarm LED Sounder
2 red blinks / 48 s Off
for 24 hours
Rapid red blinking Rapid chirping
EN
6