Fcc Compliance Statement; Industry Canada Statement - Bellman & Symfon BE1284 Manual De Instrucciones

FCC compliance statement

This device complies with Part 15 of
the FCC Rules. Operation is subject to
the following two conditions: (1) this
device may not cause harmful interfer-
ence, and (2) this device must accept
any interference received, including
interference that may cause undesired
operation.
FCC ID: 2APAKBE1284
Warning: Changes or modifications
not expressly approved by the party
responsible for compliance could void
the user's authority to operate the
equipment.
Note: This equipment has been tested
and found to comply with the limits
for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This equip-
ment generates uses and can radiate
radio frequency energy and, if not
installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or televi-
115
sion reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Industry Canada statement

This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada's
licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that
may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d'Innovation, Sciences et Développe-
ment économique Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) L'appareil ne doit pas produire de brouillage;
(2) L'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement.
This Class B digital aparatus complies with the Canadian RSS-210.
IC: 6693A-BE1284
This smoke alarm is certified to:
ANSI/UL217, CAN/ULC-S531, ANSI/UL539 and ULC/ORD-C539
For a complete Declaration of Conformity, please contact the
Bellman & Symfon European office.
Service center
Bellman & Symfon North America Inc.
5509 Business Dr, Unit B
Wilmington, NC 28405
Unites States
Phone: +1 (910) 239 5796
Toll-free: + (833) 235 5626
Email: support.bsn@bellman.com
European office
Bellman & Symfon Group AB
Södra Långebergsgatan 30
436 32 Askim
Sweden
Phone: +46 31 68 28 20
E-mail: info@bellman.com