Dmx Linking; Floor Mounting - Chauvet Professional ROGUE OUTCAST 1L BEAM Guía De Referencia Rápida

AC Power
This product has an auto-ranging power supply that can work with an input voltage range of 100–240 VAC, 50/60 Hz.
AC Plug
Connection
AC Live
AC Neutral
AC Ground
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
Replacing the Fuse
1. Disconnect the product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.

DMX Linking

The Rogue Outcast 1L Beam will work with a DMX controller using a 5-pin IP-rated DMX serial connection. A DMX
Primer is available from www.chauvetprofessional.com.
DMX Connection
The Rogue Outcast 1L Beam uses a 5-pin IP-rated DMX data connection for its DMX personalities: 17CH and 19CH. See
the User Manual for information about connecting and configuring the product for DMX operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. Check the DMX controller's User Manual or with the manufacturer, as not all DMX controllers
have this capability. The Rogue Outcast 1L Beam supports RDM protocol that allows feedback to make changes to menu
map options. Download the User Manual from
Mounting
Before mounting this product, read the
mounting clamps are capable of supporting the weight of the product. For Chauvet's line of mounting clamps, go to
http://trusst.com/productcategory/truss-clamps/.
Mounting Diagram
Safety cable
Overhead Mounting
Rogue Outcast 1L Beam QRG Rev. 3
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
www.chauvetprofessional.com
Safety Notes. Use at least one mounting point per product. Make sure the
Mounting clamps (2x)
Mounting
brackets
(2x)
Wire (Europe)
Brown
Blue
Green/Yellow
for more details.

Floor Mounting

EN
Screw Color
Yellow/Brass
Silver
Green
2