FONESTAR ZS-2000M Manual De Instrucciones página 12

EN
2. Connecting the ZS-1500/ ZS-2250/ ZS-4125 audio output to the ZS-2000M.
a. Strip one end of the prepared audio output cable jacket by 10mm, and feed the cable through the
protective cover of the power amplifier, as shown in Figure 16.
Figure 16 Schematic Diagram of a Feeding the Audio Output Cable Through the Protective Terminal Cover
b. Take the end of the cable that was fed through the protective cover of the power amplifier wiring
terminal connect the cable to the power amplifier output wiring terminal (7P green euroblock connector
of 5.08mm), and tighten the screws. Refer to Figure 17.
Figure 17 Connecting the Audio Output Cable to the Power Amplifier Input Wiring Terminal
c. Feed the other end of the audio output cable through the ZS-2000M protective cover of the terminal.
Refer to Figure 16.
d. Connect the end of the cable that was fed through the protective cover of the ZS-2000M to the power
amplifier input wiring terminal (4P green euroblock connector of 5.08mm), and tighten the screws.
Refer to Figure 17.
e. Insert the power amplifier audio output wiring terminal of the installed audio output cable into the ZS-
1500/ ZS-2250/ ZS-4125 audio output port, as shown in Figure 18.
Figure 18 Schematic Diagram of the Audio Output Wiring Terminal Installation
- 12 -