FONESTAR ZS-2000M Manual De Instrucciones página 11

VIEW IP SETTING
Touch the icon to display the IP setting interface.
VIEWING THE IP ADDRESS
The interface shown in Figure 8 appears. User can view the IP address, MASK, and the gateway address.
TROUBLESHOOTING
The following list of causes and corrective actions can be referenced when attempting to troubleshoot issues
with the ZS-200M:
Issues Possible Causes
A power failure has occurred or an
incorrect power adapter is being used
Nothing
displays on the
The ZS-200M is in the standby state
screen
The ZS-200M failure
Not familiar with the operation of the
equipment
Cannot
perform
Incorrect or invalid broadcasting ZS-
broadcasting
200M system configuration
Cannot use Incorrect or invalid ZS-200M system
the full configuration
duplex
intercom
function
Opposite party is not online
No sound
Incorrect paging operation performed
when
speaking
The volume of the ZS-200M is very low
No sound
The
when
loudspeaker is very low
monitoring
Figure 8 Viewing the IP address information
volume of the
Corrective Action
Replace the power adapter.
Note: The ZS-200M uses a DC 12V/1A power
adapter.
Press any key to "wake up" the screen so
it can be used.
Contact the appropriate equipment
vendor for timely maintenance.
Please carefully read the Operation
Manual.
Double check the configuration settings
of the ZS-200M functions through the
system configuration software
Double check the ZS-200M configuration
settings through the system configuration
software
software
The opposite party must be online to
initiate the full duplex intercom function
Follow the paging directions in section 3,
ZS200M Operations Guide
Adjust the volume of the microphone.
monitoring Adjust the volume of the monitoring
loudspeaker
- 11 -
EN