Publicidad
Idiomas disponibles
Idiomas disponibles
EMERGENCY
GATE VALVE
TROUBLESHOOTING
Other factors outside the tool may cause loss of power or erratic action. Reduced compressor output, excessive
drain on the air line, moisture or restrictions in air pipes or the use of hose connections of improper size or
poor conditions may reduce air supply. Grit or gum deposits in the tool may cut power and may be corrected by
cleaning the air strainer screen (located indside the air inlet) by flushing out the tool with gum solvent oil or an
equal mixture of SAE #10 and kerosene. If outside conditions are in order, disconnect tool from hose and take
tool to your Mac Tools Distributor for repair.
Model #
MPS1911
Model #
MPS1911
* = measurement uncertainty in dB(A)
800.MACTOOLS
1/4" NPT STANDARD FLOW FITTING
AIR HOSE 3/8" (10 mm) I.D. MIN.
SPECIFICATIONS
Cutting
Capacity
in
Pressure dB(A)
3/8"
87
Strokes Per
Minute
Consumption
spm
7,000
Always use an air line lubricator with this tool. After
every eight hours of operation, if a lubricator is not
used on the compressed air network, inject 1/2 to 1
cc of approved air tool oil (Mac Tools part #PO32)
through the tool's inlet connection.
Noise Level
Power dB(A)
3*
98
Average Air
Working
Pressure
cfm / l/min
psi / bar
4 / 113
90 / 6.2
** = measurement uncertainty in m/s²
An air filter unit should be
placed between air compressor
and air lubricator to promote
clean air supply to air saw.
Water, dirt, and scale can
damage air saw.
Vibration Level
m/s
3*
16.5
Weight
Length
lbs / kg
in / mm
2.5 / 1.1
10.5 / 267
2
2**
9
Publicidad
