Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
4 ELECTRICAL REQUIREMENTS
WARNING
This appliance must be properly grounded.
WARNING
To prevent fire or shock, do not use an extension cord with this appliance.
WARNING
To prevent shock, remove house fuse or open circuit breaker before beginning installation.
WARNING
Improper connection of aluminum house wiring to copper leads can result in an electrical hazard
or fire. Use only connectors designed for joining copper to aluminum and follow the manufacturer's recommended
procedure closely.
We recommend you have the electrical wiring and hookup of your appliance connected by a qualified electrician.
After installation, have the electrician show you how to disconnect power from the appliance.
You must use a single-phase, 120/208 VAC or 120/240 VAC, 60 Hertz electrical system. If you connect to
aluminum wiring, properly installed connectors approved for use with aluminum wiring must be used.
Effective January 1, 1996, the National Electrical Code requires that new construction (not existing) utilize a four-
conductor connection to an electric oven. When installing an electric oven in new construction, a mobile home,
recreational vehicle or an area where local codes prohibit grounding through the neutral conductor, refer to the
section on four-conductor branch circuit connections.
Check with your local utilities for electrical codes which apply in your area. Failure to wire your oven according
to governing codes could result in a hazardous condition. If there are no local codes, your oven must be wired
and fused to meet the National Electrical Code, NFPA No. 70 – latest edition, available from the National Fire
Protection Association.
Note: If using a GFI breaker, the ground wire must be installed correctly to prevent breaker from tripping. Refer to
latest edition of the NEC, NFPA No. 70, available from the National Fire Protection Association.
6
31-2000374 Rev. 1
Publicidad
