Recommended Use; Cutting Operation - Battipav SINTESI 40093 Manual De Instrucciones

Battipav srl
USE
EACH TILE CUTTER HAS BEEN THOROUGHLY CHECKED BEFORE LEAVING OUR FACTORY.
BATTIPAV WORKS FOR A CONTINUOUS DEVELOPMENT OF THE MACHINES THE COMPANY
MANUFACTURES, THEREFORE THE COMPANY RESERVES THE RIGHT TO MODIFY ITS MODELS.
NO RIGHTS CAN BE THEREFORE CLAIMED AS FAR AS DATA AND PICTURES OF THIS MANUAL
ARE CONCERNED.
The SINTESI tile cutter is a technologically advanced, high-performance product, suitable for cutting ceramic,
single-fired and stoneware materials.
• The manufacturer is not liable for the use of the SINTESI tile cutter with different tools and for cutting materials
not specified in Paragraph "RECOMMENDED USE".

RECOMMENDED USE

CUTTING TOOL: tungsten carbide engraving wheel Art.492/1
FITTING
Remove the tile cutter from the packaging and check that no parts have been damaged.
Proceed with the assembly of the SINTESI tile cutter.
IN THE FACTORY, THE SINTESI CUTTER IS ASSEMBLED FOR RIGHT-HANDED OPERATORS.
1
Position the cutting bracket and lock it in place with the fixing knob.
LEFT-HANDED OPERATORS
Using a 5 mm male hex wrench, remove the "0 degrees" stop and position it in the opposite seat (B) of the
2
bracket support.
3
Position the cutting bracket and lock it in place with the fixing knob.
TRANSPORTATION
The SINTESI tile cutter can be transported easily.
• remove the bracket from its seat;
4
• position the cutting index and the relative tile support plate on the internal side of the bracket arm;
• using the threaded hole on the support surface, fix the inverted cutting bracket with the locking knob.
4
HANDLING
5
The transport wheels allowing moving the tile cutter directly on the job site.

CUTTING OPERATION

6
a) raise the register by "0 degrees" and position the cutting bracket at a "0 degree" incline.
b) place the tile to be cut on the base, at the desired cutting point;
index and the relative tile base plate;
7
c) move the cutting lever so as to make the carriage register coincide with the two reference notches;
d) bring the scoring wheel close to the surface of the tile to be cut by acting on the two height adjustment
8
registers of the carriage;
9
e) raise the breaker;
10
f) make an incision on the glaze by using the cutting lever and exerting a constant downward pressure, along
For greater accuracy, use the cutting
GB
11