Allen + Roth LWSJ24VBR Manual De Instrucciones página 2

ASSEMBLY INSTRUCTIONS
Step 1:
Mark wall for vanity placement and note the location of the
water supply lines and drain on the back panel of vanity.
Step 2:
Move vanity (B) into proper place against the wall.
Step 3:
Install faucet, drain and supply lines (none included) to
vanity top (A) according to the instructions supplied with
those items.
v
1
v
2
B
v
3
3
ASSEMBLY INSTRUCTIONS
Step 4:
This vanity comes with the knob pre-assembled to the inside
of door. To remove the knob, unscrew the bolts located on
the front of the door. Re-install the knob to the front of the
door with the same bolts.
Step 5:
hand to correct tilting and/or level doors.
Step 6:
To mount the backsplash (C) to the wall, apply a thin bead
of silicone compound (not included) to the unpolished
A back side and bottom of the backsplash (C). Position
backsplash (C) as shown onto vanity top (A) and against
the wall. Clean any excess silicone compound before
allowing to dry.
v
4
v
5
v
6
Silicone
C
UP
A
4