Fanimation FPS7679 Serie Manual De Instrucciones página 12

How to Assemble Your Light Kit or Cap (Continued)
Option B--for use with light kit
4.
Assemble the light plate assembly to the support
bracket of the motor assembly using the two key slots
in the light plate assembly. Replace the previously
removed screw and securely tighten all three screws.
(Figure 4)
5.
Remove one of the three screws in the light plate
assembly. Retain the screw for later and slightly
loosen the remaining two screws. (Figure 5)
6. Connect the 2 single pin connectors from the light
kit assembly to the 2 single pin connectors from the
motor assembly. (Figure 6)
7. Assemble the light kit assembly to the light plate
assembly using the two key slots. Replace the
removed screw from Step 5 and secure all three
screws. (Figure 7)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
8. Secure the glass to light kit assembly by twisting in
a clockwise direction. Twist the glass gradually
it snaps onto the light kit assembly.
Do not over-tighten. (Figure 8)
Light Plate
Assembly
Motor
Assembly
Light Kit
Assembly
Light Plate
Assembly
Light Kit
Assembly
until
12
Figure 4
Light Plate
Assembly
Figure 5
Figure 6
Figure 7
Light Kit
Assembly
Glass
Figure 8