Publicidad
Idiomas disponibles
Idiomas disponibles
no
Putting
!
Remove the safety seal from the no!no! Hot Blade socket
(fig 6).
Pick up the device and turn it over. Looking inside the Hot
Blade Socket you will see an LED with a metal post on each
side. (fig 7) To install the Hot Blade grasp it by both ends.
(fig 8) Line up the two small holes on the Hot Blade with
the posts inside the Hot Blade socket and push it gently but
firmly into place. Do not use force.To remove the Hot Blade,
grasp it by both ends and gently pull it out of the Hot Blade
socket.
To install the Hot Blade, hold it so that the logo on the Hot
Blade is facing the same direction as the logo on the no!no!
(fig 9). Make sure the Hot Blade is seated all the way into the
Hot Blade socket. (fig 10)
Next connect the power supply to no!no! (fig 11)
Working With
Skin Preparation
no!no! must be used on clean, dry skin. Always be sure to clean your skin of any gels, oils,
lotions or deodorants before you begin to no!no!
Watch the Light
The signal light (fig 12) will guide you throughout your no!no! hair removal experience. It
lets you know when you are working at the right speed and warns you if the Hot Blade is
torn or missing. The signal light will not be active unless no!no! is in motion.
While gliding no!no! on the skin, the Signal Light should always be facing you. When
working at the right speed, the light will be a steady green. If the light flickers or turns off,
try adjusting your speed until the light remains a steady green as you glide.
If, at any time, the Signal Light turns red remove the Hot Blade and check it, if the wire is
damaged – replace the Hot Blade. Never use a damaged Hot Blade.
All manuals and user guides at all-guides.com
no
Together
TM
!
no
no
TM
!
!
7
6
9
10
8
11
signal light
12
7
Publicidad
