Assembly - Skil PED0900 Manual Del Propietário

ASSEMBLY

WARNING
parts, making adjustments, cleaning, or when not in use .
WARNING
could result in serious personal injury.
Connecting the Edger Attachment to the Power Head
WARNING
Installing the attachment
a. Remove the battery pack from the power head.
b. Loosen the wing knob on the power head shaft (Fig. 2a).
c. The power head has two grooves on the coupler, ONLY the groove 1 is used to connect
an attachment.
d. Align the spring-loaded pin on the attachment shaft with the groove 1 on the coupler and
push the attachment shaft into the power head shaft until the pin pops out of the groove
and you hear an audible "click" sound at the same time. (Fig. 2b).
e. Pull the attachment shaft to verify that it is securely locked into the coupler.
f. Tighten the wing knob securely.
Fig . 2a
Power-Head Shaft
Coupler
Groove 1
Removing the attachment
(Fig . 2c)
a. Remove the battery pack.
b. Loosen the wing knob.
c. Press down the spring-loaded pin and pull
the attachment shaft out of the coupler.
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the tool when assembling
I
f any parts are damaged or missing, do not operate this product until
the parts are replaced .
Never operate the power head without an attachment .
Groove 2
Wing Knob
Use of this product with damaged or missing parts
Fig . 2b
Groove 1
Fig . 2c
Pin
Attachment Shaft
Pin
2
1
11