Troubleshooting; Cleaning And Maintenance; Accessories; Technical Service - VWR Avantor INCU-Line IL 23R Cool Manual De Instrucciones

Troubleshooting

Review the information in the table below to troubleshoot operating problems.
Display
Temperature probe fault, electronic board
Er1
fault or incorrect setting of parameters.
Overheating of the electronics.
Er4

Cleaning and maintenance

Prior to any cleaning or maintenance of the unit, disconnect the power cord from the wall
outlet.
When you are using the unit for cooling, some drops of water could condense on the inside of the chamber.
Use a soft cloth to wipe the inside of the chamber, if necessary.
Clean the unit internally and externally with a damp cloth and mild soap. Do not immerse the unit or spill liquids
into or on the unit. Use of alcohol or ammonia-based cleaners on the door may cause it to crack. Allow the
incubator to dry completely inside and outside, before reconnecting the power and using it again.

Accessories

Description
Extra shelf, 286 x 285 mm, stainless steel
Tube rack, 2 x 6 positions, Ø 32 mm

Technical service

Web Resources
Visit the VWR website at
• Complete technical service contact information.
• Access to VWR Online Catalogue, and information about accessories and related products.
• Additional product information and special offers.
Contact us
For information or technical assistance contact your local VWR representative or visit www.vwr.com.
8
vwr.com I EN Instruction manual VWR
Cause
www.vwr.com for:
® INCU-Line IL 23R Cool
Contact your distributor.
Turn the main switch off and wait for the
device to cool down. Then you can use the
incubator again.
Quantity Cat. No.
1 390-0483
1 390-0386
Solution