Pedal Installation - KAISDA K2 Manual De Instrucciones

4. Front wheel installation：
4.1 Cut the wrapping rope, remove the front wheel, remove the front fork protection
rod and the front wheel protection cover.
4.2 Make sure the front and rear wheels are in line before mounting.First pull the
wheel up, place the disc brake disc into the front brake clamp, then use the No. 15
wrench to tighten the front flower drum fixing screw.
4.3 Adjust the adjusting screw of the disc brake so that the disc brake can rotate
without obvious friction
5. Pedal installation：
5.1 Check the two pedal. The pedal with "L" printed on the end of the core shaft
should be installed on the left side of the vehicle (without toothed disc) and rotate
counterclockwise. The pedal with "R" is installed on the right side (with toothed disc)
and rotate clockwise, then use the No.15 wrench
Tighten the foot core shaft (pay attention to screw the foot up by hand and then lock
it with a wrench).
-5-