Publicidad
Idiomas disponibles
Idiomas disponibles
English
Our products are designed to meet the
highest standards of quality, functionality and
design. We hope you enjoy your new Braun
shaver.
Warning
Your shaver is provided with a special cord
set with integrated Safety Extra Low Voltage
power supply. Therefore you must not ex-
change or manipulate any part of it. Otherwise
there is a risk of electric shock.
Description
1 Shaver foil
2 Cutter block
3 Release button
4 «on/off» switch
5 Long hair trimmer
6 Dual function light
green: charging
red:
low-charge
7 Special cord set
Charging
The best environmental temperature for
charging is between 15 °C and 35 °C.
•
Using the special cord set, connect the
shaver to an electrical outlet with the motor
switched off.
•
When charging for the first time, leave the
shaver to charge continuously for 4 hours.
Subsequent charges will take about 1 hour.
•
As soon as you start charging the shaver,
the green charging light (6) comes on.
When the batteries are fully charged, the
green light goes off. If it comes on again
while connected to an electrical outlet,
this indicates the shaver is recharging to
maintain its full capacity.
•
Once the shaver is completely charged,
discharge the shaver through normal use.
Then recharge to full capacity.
•
A full charge will give up to 40 minutes of
6
cordless shaving time depending on your
beard growth. However, the maximum
battery capacity will only be reached after
several charging/discharging cycles.
•
When the batteries are running low, the
dual function light (6) turns red (provided
the shaver is switched on). The red light
indicates the shaver capacity has dropped
below 20%, which is sufficient for 2 to 3
shaves.
•
When fully discharged, you may also shave
with the shaver connected to an electrical
outlet via the special cord set.
Shaving
Press the «on/off» switch (4) to turn the shaver
on.
Trimmer: When the long hair trimmer (5) is
activated, it allows controlled trimming of
moustache or sideburns.
Tips for the perfect shave
•
We recommend that you shave before
washing, as the skin tends to be slightly
swollen after washing.
•
Hold the shaver at right angles (90°) to the
skin. Stretch the skin and shave against
the direction of beard growth.
•
To maintain 100% shaving performance,
replace your foil and cutter block every 18
months or when worn.
Cleaning
Always unplug the appliance before cleaning.
Regular cleaning ensures better shaving
performance. Rinsing the shaving head after
each shave under hot running water is an easy
and fast way to keep it clean:
•
Switch the shaver on (cordless) and rinse
the shaving head under hot running water.
A natural based soap may also be used
provided it contains no particles or
Publicidad
