Publicidad
Idiomas disponibles
Idiomas disponibles
GB
8. Ensure that the engine ventilation
slots, protective cover and cutting
device are always free of dirt or resi-
dues.
9. During the work processes, always
ensure that there are neither people
nor animals within a radius of at least
15 m. Switch off the equipment im-
mediately if anyone and particularly a
child comes into the range of the ma-
chine.
When using the equipment, stones
and other elements that can cause
serious injuries can be thrown out.
10. When the equipment is in operation,
keep away from the moving parts (in
the area of the cutting devices).
After switching off, the cutting head
continues to turn for a few seconds.
11. Before using the equipment, remove
stones, twigs and any other solid ma-
terial from the working area.
Start the machine only as described in
the instructions. It must not be turned
upside down or be in the working po-
sition when it is started.
Do not cross gravel roads or paths
with the equipment running.
12. The greatest care is required when
extending the cutting thread. Risk of
injury from cuts. After executing these
processes, reassume the correct
working position before switching on
the equipment.
13. Do not use metallic cutting reels or
saw blades. Note that the equipment
remains in operation for a few sec-
onds after the switch is released.
14. Switch off the engine when:
-
Not using it,
-
Leaving it unattended,
-
Cleaning it,
-
Transporting it from one location to
another,
52
-
Removing or replacing the cutting de-
vice and manually adjusting the length
of the cutting thread.
Precautions to Prevent Recoil
In case of recoil, the user receives
a powerful jolt from the motorised
strimmer. This may result in loss
of control of the equipment and
in serious injury. Recoil can be
avoided by care and correct tech-
nique.
When the metal cutting blade is used,
there is a risk of recoil if the blade edge
hits an obstacle (stone, wood).
•
Hold the equipment firmly in both hands.
•
Ensure that there are no obstacles on
the ground and do not use the metal
cutting disk near fences, metal posts or
similar.
Symbols in the Instructions
Warning signs with details for the
prevention of personal and prop-
erty damage.
Command signs (instead of the
exclamation mark, the command is
explained) with details for the pre-
vention of damage.
Information signs with information
for better handling of the equip-
ment.
Use only well sharp-
ened tools. To cut
thick stems, place the
equipment in position
A.
Publicidad
