Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Standard settings
Refer to the table below to adjust the image size and projector distance (fig. 3).
EN
•
During installation, place the projector on a stable surface or set it on a
stand. Do not cover or block ventilation holes.
•
If the distance between the projector and the screen is less than the
minimum distance or is much greater, the image may be blurred.
Device operation
Switching on and off
•
When the projector is connected to the power source, it enters standby
mode. The indicator light will turn red.
•
To turn the projector on or off, press the on/off switch on the top of the
cabinet or the on/off button on the remote control. The projector is ready
for operation when the light turns blue.
Focus adjustment
•
Place the projector so that the lens remains perpendicular to the wall or
screen on which the image is to be projected.
•
o improve the focus of the projected image, turn the focus knob on the
top panel until the image comes into focus.
•
If the image is not displayed perpendicularly, it will be distorted.
Signal source settings
Switch on the projector, and then select your preferred signal source in the
main interface (fig. 4).
Proportion ratio
Image size (inches)
50
70
100
120
150
16:9
Projection distance
1,53
2,14
3,03
3,60
4,50
Publicidad
