Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
To ensure that the appliance operates properly and to reduce energy consumption, it is important that the appliance is
installed correctly.
•
Avoid positioning the appliance near cookers, radiators or in direct sunlight, as this will cause the compressor to run
for long periods. If installed next to a source of heat or refrigerator, maintain the following minimum side clearances:
From Cookers
From Radiators
From Fridges
Make sure that sufficient room is provided around the appliance to ensure free air circulation. Ideally, A space of no less
than 10cm must be left around the freezer, and ensure you allow gaps as shown in the below diagram.
•
The appliance should be located on a level surface.
•
It is advised not to use the refrigerator outdoors.
Protect from moisture. Do not locate the freezer in a moist area to avoid the metal parts becoming rusty, do not
•
spray water to the freezer; otherwise it will weaken the insulation and causes current leakage.
•
Refer to "Cleaning and Care" section to prepare your appliance for use.
If the freezer is installed in unheated areas, garages etc in cold weather condensation may form on the outer surfaces.
This is quite normal and is not a fault. Remove the condensation by wiping with a dry cloth.
STARTING
Before using the freezer, please read below:
•
Make sure that the interior is dry and keep air circulating at the back of cabinet.
•
For the details concerning the method of cleaning, please see section "CLEANING AND CARE"
After Inserting the plug into the socket, the LED lights and digital display will illuminate for a while and will return to
•
normal after 2 seconds; In setting mode, if no button is pressed within 5 seconds, all buttons will be locked automatically.
Temperature can be set between - 24℃ ~ - 16℃. The default temperature setting is -18℃.
•
•
You may hear some noise as the compressor starts running. The liquid and gas in refrigeration system may also
make noise, no matter the compressor is running or not. This is a normal phenomenon.
Before storing the food which are already frozen, please open the freezer door and check if the freezer has reached
•
the correct temperature. Then put into the frozen food.
Do not load the appliance immediately just after it is switched on. Wait until the correct storage temperature has
•
reached. We recommend that you check the temperature with an accurate thermometer.
•
Due to individual factors of the refrigerator, the actual temperature in the box may have a certain error
from the set temperature, which is a normal phenomenon and does not affect the normal use of the
product.
Important Notes:
If there is a power failure, do not open the door. Frozen food should not be affected if
•
the power failure lasts for less than 38 hours. If the failure is longer, then the food should be
checked and eaten immediately or cooked and then refrozen.
•
If you find that the door of the chest freezer is difficult to open just after you have
closed it. Don't worry about it. This is due to the differential pressure, which will be
equalized and allow the door to be opened normally after a few minutes.
FREEZER OPERATION
Unlock Settings
Under the lock state, press both the "Up" and "Down" buttons at the same time for 1s, then
operation buttons get unlocked. And Parameter setting is enabled, with the current
temperature setting flickering.
Press "Up" key once, the temperature increases by 1 ℃; Press "Down" key once, the
•
temperature decreases by 1 ℃; If no button operation within 5 seconds after each setting,
the current set temperature shows on display will be fixed by the system automatically.
Then the display will stop flickering.
Press the "Super FRZ. " button, the temperature is set to - 30℃automatically, digital flickers " - 30 ℃". And meantime
Super-Freezing function
•
the indicator light of "Super FRZ. "is on, The flickering will stop in 5 seconds, then Super-Freezing function starts.
After running 26 h, Super-Freezing function will stop automatically. The indicator goes out. It reverts to previous state.
•
4" (100 mm)
12" (300 mm)
4" (100 mm)
Publicidad
