Descargar Imprimir esta página

Pelonis HO-0280 Manual Del Usuario página 3

Calentador digital tipo radiador con aceite

Publicidad

Idiomas disponibles

Idiomas disponibles

15. This heater draws 12.5 amps during operation. To prevent overloading a circuit,
do not plug the heater into a circuit that already has other appliances working.
16. It is normal for the plug to feel warm to the touch; however, a loose fit between
the AC outlet (receptacle) and plug may cause overheating and distortion of the
plug. Contact a qualified electrician to replace loose or worn outlet.
17. The output of this heater may vary and its temperature may become intense
enough to burn exposed skin. Use of this heater is not recommended for
persons with reduced sensitivity to heat or an inability to react to avoid burns.
18. Don't leave the heater on unattended.
19.
ASSEMBLY INSTRUCTIONS
Unpack your heater and find the wheel-holding plate and butterfly nuts between
the fins assemblies .
1. Make sure the heater is unplugged and in the "OFF" position.
2. TURN THE HEATER UPSIDE DOWN.
3. Attach the wheel-holding plates onto the heater as Fig.1 shows . The plate is
fixed between the last two fins and the other one is fixed under metal control box,
Fix the castors to the vertical axis of both
the wheel holding plates.
4. Insert the butterfly nuts and tighten them
securely .
5. TURN THE HEATER UPRIGHT.
Your heater is now ready to use .
Risk of fire. Do not operate heater without wheel assemblies
attached. Operate heater in upright position only (wheels on bottom,
controls on top). Any other position could create a hazardous situation.
Ensure that the surface beneath the heater is clean and free of any
obstructions. It is not recommended that this heater be placed on
high-pile carpeting or any other surface that impedes the flow of air
underneath the heater.
This heater includes an Overheat Protection System that
shuts the unit off if it overheats due to abnormal conditions.
If this occurs turn the heater "OFF", unplug it, and inspect and remove
any objects on or adjacent to the heater. Allow it to cool for a few
minutes, plug it back in, and resume normal operation.
Fig.1
2

Publicidad

loading