Descargar Imprimir esta página

Pelonis HO-0280 Manual Del Usuario página 5

Calentador digital tipo radiador con aceite

Publicidad

Idiomas disponibles

Idiomas disponibles

Note:
1. When the child lock is in effect during startup, all operations other than shutdown
invalid (except release of the child lock); the child lock is canceled after shutdown.
2. When the child lock is in effect during standby, all operations are invalid (except
release of the child lock).
<Memory function>: If the machine is restarted after normal shutdown, it will run at
the latest state before shutdown. If the machine is powered on again after power
off, it will also run at the latest state before power off.
Note: The memory function is not applicable to child lock after power off.
<Safety protection function>: If the indoor environment temperature Th exceeds
122°F during standby or startup time, please close all output, the buzzer will give
ten acute sounds, and the digital display will show "FF" and flash for 75 seconds
with the frequency of 1HZ. If the protection function works, the machine cannot
resume running or operation, though the environment temperature is less than
122°F. In this case, it is necessary to power off and then power on the machine for
operation.
<Shutdown>: When the machine is turned on, press the "
panel to enter the standby state. Unplug the power cord, and then place the electric
heater well after the machine is cooled.
[Electric heater movement]
To move the electric heater, please turn it off, unplug the power cord, and then
push the heater body to make the following four universal casters to scroll.
Note: In the event of first use or re-inserting the power plug into socket, please
check the compatibility of the plug and socket.
Inspection method: Insert the power plug into socket and turn the machine on.
About half an hour later, shut the machine down and disconnect plug to check
whether the plug pin is hot. If the pin is hot (about more than 122°F), the socket
must be replaced to avoid socket overheating and even fire caused by poor
contact.
Temperature decrease
:
ON/OFF button
:
Temperature increase /
:
Timer button
:
Mode button
:
4
" key on the control
/ Time decrease
Time increase

Publicidad

loading