Publicidad
Idiomas disponibles
Idiomas disponibles
Extension Cords
Only use extension cords that are intended for indoor use. These extension
cords are identified by the statement: "Acceptable for use with indoor
appliances; store indoors while not in use". Only use extension cords with an
electrical rating that is higher than the rating of the product. Do not use
damaged extension cords. Examine extension cord before using and replace
if damaged. Do not abuse extension cords and do not yank on any cord to
disconnect. Always disconnect the extension cord from the receptacle before
disconnecting the product from the extension cord. Keep cord away from heat
and sharp edges.
WARNING - To reduce the risk of electric shock, keep all connections dry and
off the ground. Do not touch plug with wet hands.
USING YOUR ROBERTS SEAMING IRON
1. Select a clear area near the beginning of the carpet seam to place iron
for heating.
2. Place all required materials and tools within reach.
3. Set the iron in its base and place the base on a solid surface, such as a
piece of plywood or a piece of scrap carpet.
4. If needed, make sure an extension cord is long enough to reach the end
of the seam.
5. Plug the iron into a household (120-volt) socket and set the thermostat
control located on the front of the handle to desired temperature setting.
Consult tape manufacturer's instructions for the proper heat range. The
chart below shows the thermostat knob settings for various temperature
ranges.
NOTE: Recommended setting for Roberts Heat Bond tapes is 2-3 on the
temperature control knob.
Number
on Knob
1
1-1/2
2
2-1/2
3
3-1/2
4
Temperature Range
Min ˚F
Max ˚F
˚F
˚F
125.6
161.6
˚F
˚F
170
224
˚F
˚F
212
253.4
˚F
˚F
266
322
˚F
˚F
330.8
366.8
˚F
˚F
339
396
˚F
˚F
392
428
Min ˚C
Max ˚C
52˚C
72˚C
76˚C
107˚C
100˚C
123˚C
129˚C
161˚C
166˚C
186˚C
170˚C
203˚C
200˚C
220˚C
– 3 –
Time to Reach
Temperature
1-1/2 minutes
2 minutes
2-1/2 minutes
3 minutes
3-1/2 minutes
3-3/4 minutes
4 minutes
Publicidad
