Roberts 10-282G-2 Manual Del Usuario página 4

6. Allow the iron to reach operating temperature according to the chart
above. The light on top of the handle will stay red while the iron is
heating. The light will turn green when the iron has reached operating
temperature.
7. Let the iron cycle several times before seaming.
8. Test the iron for proper temperature on tape or a piece of scrap tape to
get the desired melting of the adhesive.
MAINTENANCE OF NON-STICK COATED BASE PLATE
The base plate is coated with a tough non-stick coating to provide a long
lasting easy to clean surface. To preserve this finish:
1. Always put the iron in its holder when not seaming.
2. Never try to clean the base with a wire brush, knife, or any hard material.
3. Do not place iron on concrete or other hard surfaces.
4. When storing, put the iron in its holder.
5. ALWAYS CLEAN IRON AFTER EVERY USE.
6. To clean iron, rub the base over a piece of clean scrap carpet while the
iron is still hot.
CUSTOMER SERVICE NUMBER: 1-866-435-8665
– 4 –