Operation - Maxvac Dustblocker PRO Instrucciones De Uso Y Mantenimiento

First switch the device's switch to off (O - position) before removing the plug
from the socket. If the switch is on "I position , sparks may be generated
between the socket and the plug of the device.
Prior to performing maintenance, first remove the plug from the socket in order
to prevent electrical shock.
When replacing the pre filter or hepafilter it is possible that dust is dispersed
that can be dangerous for people's health. Therefore, users should wear safety
glasses, safety gloves and a respiration mask that comply with protection class
FFP3.
Do not drill through or break open the H14 HEPA filter.

OPERATION

The operating panel is at the side of the Dustblocker Pro and is identical for all
models. At the top of the operating panel you will see from left to right:
Red LED with a warning signal (gives a
signal if the a filter has to be replaced.)
Orange LED with a warning signal
(gives a signal in case of leaks/pressure
drops in the filter system)
Red mains switch; position I (on) & O
(off)
In addition, you will find a mains socket
for connecting to the mains
Euro & Blue = 220volts
Yellow = 110volts)
Connect the plug to the socket and
press the red switch to start the device.
DB PR O
MAX-VAC.COM 7