LUND 67182 Manual Original página 10

GB
pets, carpet fl oorings, and similar materials. This could destroy the pads or even the mop itself.
Do not clean cigarette butts, matches, or hot ash.
Do not clean fi ne dust, e.g. fl our, gypsum, printer toner, etc. Do not use the mop for cleaning
industrial waste, e.g. sawdust, debris, metal fi lings, etc.
APPLIANCE OPERATION
CAUTION! Turn off the appliance and make sure the power switch is in the OFF position, before carrying out any assembly and
disassembly of its accessories.
Appliance assembly and disassembly
Unpack all elements of the appliance and remove all packaging components.
Before fi rst use, the appliance must be properly assembled. Insert the handle extension into the head so that the lock that holds
it in place engages. Similarly, fi x the handle to the other end of the extension (II). If you need to disassemble the mop, press and
hold the lock button, and then slide the handle out of the extension and extension from the head.
Before installing a microfi bre pad, dampen it with water and then squeeze out excess water.
The microfi bre pads should be attached to the head discs (III) with Velcro. Try to place the pads concentrically on the discs, so
that they do not come into contact with each other during rotation. The microfi bre side must be facing outwards. It will be easier to
ensure a precise installation if the pad is fi rst folded in half, attached to the head disc, and then unfolded so that the pad's entire
surface adheres to the disc.
Charging the battery
Check that the switch located on the battery housing is in the off position, marked "OFF". Install the battery in the mop housing
compartment by pressing it gently until the latch mechanism engages (VI).
Connect the charger's cable to the socket in the battery housing (VI), and then plug the charger itself into a mains socket. Move
the switch to the "ON" position; this will result in displaying percentage battery charging level on display located below the charging
socket. When the display shows 100, move the switch to the off position, and then unplug the charger from the mains outlet and
the mop.
Caution! Do not use the cleaning appliance during charging.
Warning! Do not leave the appliance connected to the charger, after charging. Otherwise, it will damage the battery or the appli-
ance itself.
Safety instructions for battery charging
Caution! Before starting charging, make sure that the charger body, cord and plug are not cracked or damaged. It is forbidden to
use a defective or damaged charger! Use only the supplied accessory charger to charge the batteries. Use of another charger may
result in fi re or damage to the device. The battery should only be charged in a closed, dry room, protected against unauthorised
access, especially by children. Do not use the charger without the constant supervision of an adult! If you need to leave the room
where the vacuum cleaner is being charged, disconnect the charger from the mains by removing the charger plug from the socket.
If smoke, odours, etc. are escaping from the charger, remove the charger plug from the socket immediately! The product is sup-
plied with an uncharged battery and should therefore be charged according to the procedure described in the manual before use.
Li-ion (lithium-ion) batteries do not have the so-called "memory eff ect", which allows them to be recharged at any time. However, it
is recommended to discharge the battery during normal operation and then charge it to full capacity. If, due to the nature of work,
it is not possible to use the battery in such a manner every time, it should be done at least every several work cycles. Never dis-
charge the batteries by closing the battery contacts, as this will cause irreparable damage! Also, do not check the battery charge
status by closing the contacts and checking sparking.
Battery storage
If possible, it is recommended to disconnect the battery from the product for storage. Proper storage conditions will help to extend
the life of the battery. The battery lasts for about 500 charge-discharge cycles. Store the battery in a temperature range from 0 to
30 degrees Celsius at a relative humidity of 50%. To store the battery for a longer period of time, it should be charged to approx.
70% of its capacity. In case of prolonged storage, the battery should be periodically charged once a year. Do not over-discharge
the battery as this will shorten its life and may cause irreparable damage. During storage, the battery will gradually discharge due
to leakage. The self-discharge process depends on the storage temperature, the higher the temperature, the faster the discharge
process. If the batteries are stored incorrectly, the electrolyte may leak. In case of leakage, secure the leak with a neutralising
agent, in case of electrolyte contact with eyes, rinse eyes thoroughly with water, and seek medical attention immediately. It is
forbidden to use the device with a damaged battery. If the battery is completely used, return it to a specialist waste disposal centre.
Transport of batteries
Lithium-ion batteries are treated as hazardous materials according to legal regulations. The user of the device can transport the
O R I G I N A L I N S T R U C T I O N S
10