Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE
ISTRUZIONI PER L'USO
OPERATING MANUAL AND INSTRUCTIONS MANUFACTURED BY:
BETA UTENSILI S.P.A.
Via A. Volta 18, 20845, Sovico (MB) ITALY
Original documentation drawn up in ITALIAN.
CAUTION
TECHNICAL SPECIFICATIONS:
MODEL
3010V 680
3010V 1170
WARNINGS:
Jack stands should only be used to support loads; they are not meant to be used as lifting
apparatus.
Do not overload jack stands beyond rated capacity.
Overloading can cause structural damage to jack stands, thereby resulting in severe consequences
for people and property.
Always make sure that the load is placed as perpendicularly as possible to the jack stand,
and that the base of the jack stand entirely lies on the ground.
Always use a proper number of jack stands, according to the load to support, and check that the
floor is flat and as hard as required to maintain the load.
Use on other than hard surfaces can result in load loss, and thus in severe personal injury or
property damage.
USE:
Always refer to the vehicle's operation and maintenance manual for proper jacking procedures.
Use only such points of support as specified by the vehicle manufacturer.
JACK STAND ADJUSTMENT:
Position the jack stands under the vehicle, making sure that the vehicle's points of support are used.
Turn the cross wrench as much as required to reach the desired height; then gently lower the load onto
the jack stands.
MAINTENANCE AND INSPECTION
It is recommended to check the jack stands before each use, making sure that no parts are missing,
and that no cracks, cracked welds or structural damage are shown.
Because the misuse of equipment of this type may result in severe damage, the products must
not be modified in any way.
IMPORTANT! READ THIS MANUAL CAREFULLY BEFORE USING.
FAILURE TO COMPLY WITH THE SAFETY
STANDARDS AND OPERATING INSTRUCTIONS MAY RESULT IN
SERIOUS INJURY.
MAX. CAPACITY
20 t
20 t
MIN. HEIGHT
MAX. HEIGHT
410 mm
665 mm
BASE
DIMENSIONS
600 mm
300x300 mm
1090 mm
300x300 mm
EN
I
3
Publicidad
