Aqua Optima PJ Serie Manual De Uso página 4

READ ALL INSTRUCTIONS BEFORE USE AND SAVE THEM
EN
FOR FUTURE REFERENCE
WARNING
This product is intended to filter tap water only. Do
not put water of unknown quality or that has been
microbiologically contaminated into the product.
BEFORE USING THE FILTER JUG FOR THE FIRST TIME
1. Remove all packaging from the jug.
2. Remove the lid from the jug and wipe it with a clean
damp cloth.
3. Remove the inner vessel and wash it thoroughly.
PREPARING THE WATER FILTER CARTRIDGE
1. Remove all packaging from the filter cartridge. There
may be a small residue of black carbon particles in the
bag or on the surface of the cartridge; this is normal.
These particles are harmless and are washed off during
the preparation process.
2. Soak the cartridge in a bowl of water for 5–10 minutes
to remove all the air bubbles (1).
3. Rinse for 1 minute under a running tap (2)
4. The filter cartridge is now ready for use.
FITTING THE FILTER INTO THE INNER VESSEL
1. Fit the Aqua Optima filter cartridge into the
underside of the inner vessel and rotate clockwise to
lock into place. Ensure that it is firmly secured (3)
2. Place the inner vessel back into the filter jug.
3. Refit the lid.
4. Fill the inner vessel with cool water and let it pass
through the filter. Once it has been filtered, discard
the water. Repeat the procedure once more (4).
5. Fill the inner vessel for a third time, your water filter
jug is now ready for use (5).
This system has been tested according to NSF/ANSI 42 and NSF/ANSI 53 for reduction of the substances listed
below. The concentration of the indicated substances in water entering the system was reduced to a concentration
less than or equal to the permissable limit for water leaving the system, as specified in the standard.
Substance
Chlorine
Mercury
The PJXXXX has been tested and certified by WQA against NSF/ANSI 53 for the reduction of
mercury, NSF/ANSI 42 for the reduction of chlorine, taste and odor, NSF/ANSI/CAN 372 for lead
free compliance and CSA B483.1.
Rated service flow 0.88 gallons/day
While testing was performed under standard laboratory conditions, actual performance may vary.
Do not use with water that is microbiologically unsafe or unkown quality without adequate disinfection before or
after the system. Min temp 5�C/41�F. Max temp 28�C/82�F. No warranty is made for use with water outside of
these temperatures.
Manufacturers Limited Warranty
The device has a one year manufacturers limited warranty.
AQUA OPTIMA 30-DAY FILTER CARTRIDGE
To ensure the best performance, the filter cartridge
should be changed after 26.6 gallons, which is
approximately 4 weeks of typical use.
REPLACING THE FILTER CARTRIDGE
• Remove the lid and lift out the inner vessel.
• Hold the inner vessel and rotate the cartridge
anticlockwise to release it.
• Prepare and insert the new cartridge as described
above.
FOR BEST RESULTS
• To prevent the filter from drying out, it should not
be left unused for long periods. If such an extended
period is anticipated (such as a holiday), then it is best
to remove the filter and store it in a sealed plastic
bag. The filter can then simply be prepared as per the
original fitting instructions. Refer to Preparing the
water filter cartridge above.
• Store the filter jug in the refrigerator or in a cool
place. It is important to store the jug out of direct
sunlight and away from heat sources.
• Wash and rinse the inner vessel and jug regularly. The
lid should be wiped clean with a damp cloth.
• Use only cold or room temperature water for filtering.
• Only use mild cleaning agents, never solvents or
corrosive chemicals. Never use abrasive pads on this
product.
• Do not use the filter jug for any other purpose than
for filtering water.
Influent challenge concentration
(mg/L)
2.0 ± 10%
0.006± 10%
Maximum permissable product
water concentration
≤50%
0.002mg/L