Infiniton HG-FL3 Manual De Usuario página 17

Lighting Instructions:
The heater can be regulated to three different settings: 1-LOW, 2-MEDIUM and 3-HIGH. Ignition
mode: piezo ignition.
Open the valve on the heater cylinder 1 and 1/2 turns.

Press down and turn the control knob to 1-LOW position and hold for 10 seconds.

While still pressing down the pilot light, press once or twice on the ignition button until

the pilot light (at the bottom of the burner) ignites. Continue to hold the control knob down
for 10-15 seconds more. Release the button, and if the pilot flame goes out, repeat the above
operation.
Note: when lighting a new heater for the first time, it might be necessary to hold the control
knob down for longer time in order to allow gas to flow to the pilot
Once the heater in/on/at the 1-LOW setting, turning the control knob to 2-MEDIUM or 3-HIGH
position will light the second and third panel respectively.
To turn off the heater, turn back the control knob to the OFF position and close the cylinder
valve fully(clockwise). The heater can only be turned off by closing the cylinder valve. It can not