PICO 4 Guia Del Usuario página 8

Operating Instructions
Headset Control Mode
If the Controller is not connected, you can interact with the home screen by moving your head to direct
the crosshairs over your intended selection and clicking the Volume Up/Down button on the VR Headset.
Switch the pointer of the master Controller
In the home screen, short press the Trigger of the corresponding Controller to switch the pointer of the
EN
master Controller.
Screen re-centering
Wear the VR Headset and look straight ahead, press and hold the Home button of the Controller or VR
Headset ( or the Volume Down button of the VR Headset in head control mode) for more than 1 second to
re-center the screen.
Disconnect the Controller
Press and hold the Home button until the status indicator turns red and the Controller vibrates.
Controllers will automatically shut down to save power in the following cases:
When the VR Headset enters deep sleep (a while after the VR Headset is taken off)
When the Controller is unpaired
When the VR Headset is powered off
Add a new Controller
If you need to add a new Controller (the VR Headset can only connect one left Controller and one right
Controller) or reconnect with an unpaired Controller. Go to "Settings" ► "Controller", click on "Pair".
Press and hold the Home button and the Trigger of the Controller at the same time until the red and blue
lights of the Controller flashing alternately, and then follow the instructions on the VR Headset screen.
Sleep / Wake up
Option 1 (Proximity Sensor) Take off VR Headset for automatic sleeping: wear the VR Headset for automat-
ic waking up.
Option 2 (POWER Button) Press the Power button of the VR Headset for manual sleeping or waking up.
08
Hardware reset
VR Headset reset
If the visual in the VR Headset freezes, or the VR Headset does not respond after short press the Power
button, you can press the Power button of the VR Headset for more than 10 seconds to reboot the VR
Headset.
Controller reset
If the virtual Controller, the Home button or any buttons of the Controller doesn't respond, remove and
reinstall the battery case to restart the Controller.
The VR Headset Adjustment
This device has no myopia adjustment function. The VR Headset allows wearing most standard glasses
with a frame width of less than 150mm.
to install Glasses Spacer to increase the space. You can install or not according to your situation.