Electrical Connection; Overheating Protection & Reset; Design And Function; Overview - CASO DESIGN HW 1660 Manual De Instrucciones

12.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device. If in doubt, ask your qualified electrician.
 The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or gangs
is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under the ice
maker or over hot or sharp surfaces.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician. The manufacturer cannot be made responsible for
damages that are caused by a missing or damaged protective conductor.
12.7 Overheating protection & reset
press reset button. Please use enclosed reset-key for the reset-
button.

13 Design and Function

In this chapter, you'll find important information on the design and function of the device.

13.1 Overview

► Warning symbol: hot steam.
► Caution hot steam can escape at device. Risk of burns.
The device is equipped with an overheating
protection facility. If the temperature of the
device exceeds the critical limit the device
shuts off further power supply for safety
reasons.
By pressing the reset button (1) the device
can be reactivated.
Unplug the device before reset. When the
device is only producing cold water please
Warning
34