Error Code Lo Lack Of Water; Calibration; Cleaning And Maintenance; Safety Information - CASO DESIGN HW 1660 Manual De Instrucciones

Idiomas disponibles

► Spare water filters are available separately.

Set of 6 = Caso Item No. 1841, Set of 3 = Caso Item No. 1861

► The lifetime of the waterfilter lasts about 4-6 weeks of normal use (filtering of

approximately 160 l water in total).

14.2.3

Error code Lo Lack of water

If the device stops to operate with a beeping sound and the display shows the error code Lo

Lack of water, it means that there is too little water or no water in the water tank. Please fill

in enough water into the water tank immediately.

14.2.1

If you want to optimize the temperature or volume of water, then you can calibrate the device.

Fill the tank up to max marking.

Place vessel below the spout which can collect whole content of watertank.

Press and hold

shown press Start/Stop for confirmation. The device perfoms the calibration and beeps once

process is finished.

This chapter provides you with important notices with regard to cleaning and maintaining the

device. Please observe the notices to prevent damages due to cleaning the device incorrectly

and to ensure trouble-free operation.

Please observe the safety instructions, before cleaning your device

► Unplug the device when not in use and before any cleaning.

► Never immerse the device, cord or plug in water or other liquids and do not place in the

dishwasher.

► Do not use iron brush, abradant, kitchen cleaner, or sharp cleaning tool for cleaning.

Please note

-button for 3 seconds until „CAL" is displayed. When volume "000" is

Attention

Tabla de Contenido

1884