Parameter Setting - Jeep JE-MX27.5+ Manual De Instrucciones

Parameter setting

Press and hold the "+" and the "-" buttons together, to enter in the Setting mode.
Press and hold again the two buttons together to quit the Setting mode.
In Setting mode, press the power button to save the parameter and switch to next parameter.
Press the "+" or the "-" button to increase or decrease the parameter value.
You are responsible of any adjust of these settings. Contact your Retailer or the after-sale-service for
immediate support.
P00 Code - Restore Factory Settings
P01 Code - Backlight Brightness
1: darkest 3: brightest level
P02 Code – Change Mileage Unit
0: KM 1: MILE
Code P16 – ODO Reset
Hold "+" button pressed for 5 seconds to reset the ODO distance information.
11