Adding The Control Point To A Simu Motorisation; Memorising The Control Point - Simu DIGICODE HZ 2C Guia De Instalacion

DIGICODE HZ 2C
Adding the control point to a SIMU
motorisation

Memorising the control point

1. Enter PROG mode on the motorisation (refer to the instructions of the automatism or receiver).
2. Enter main code on the control point.
3. Press simultaneously on operating buttons.
4. Choose operating button.
1
PROG
2s
©
Copyright
2022 SIMU SAS. All rights reserved.
2 3
+
4
25