Safety And Maintenance; Cleaning The Microphone; Technical Specifications - SE Electronics sE4400 Manual Del Usuario

Safety and maintenance

Cleaning the microphone

The microphone should only be cleaned with a soft cloth. Do not use any cleaning agents or aggressive
liquids.

Technical Specifications

Capsule
Polar patterns
Frequency range
Sensitivity
Max. SPL (0.5% THD)
Equivalent noise level
Dynamic range
Signal-to-noise ratio
Low cut filter
Attenuation pad
Powering
Electrical Impedance
Recommended load impedance
Current consumption
Connectivity
Dimensions
Weight
Risk of damage
Please make sure that the piece of equipment to which your microphone will be
connected fulfils the safety regulations enforced in your country and is fitted with a
ground lead.
Hand-crafted 1" true condenser capsule
Cardioid, Hypercardioid, Omni-directional, Figure-8
20 – 20,000 Hz
25 mV/Pa (-32 dBV)
137 / 147 / 157 dB
13 dB(A)
124 / 134 / 144 dB (0/10/20 dB Attenuation pad)
81 dB
40 / 80 Hz, 6 dB/Oct, switchable
10 / 20 dB, switchable
48 Volts according to IEC 61938
22 Ohms
>1k Ohms
3.7 mA
3-pin male XLR connector
58 x 29 x 146 mm ( 2.32 x 1.10 x 5.75 in.)
290 g (10.23 oz.)
(0/10/20 dB Attenuation pad)
SPL
4