Indicator Light; Installing A Microsd Card; Restore Factory Settings - imilab C20 Pro Manual Del Usuario

Indicator Light

Steady blue on: connected/device status is normal
Flashing blue: network error
Flashing orange rapidly: waiting for connection
Flashing orange slowly: system upgrade in progress

Installing a MicroSD Card

Make sure that the power to IMILAB C20 Pro is already disconnected. Adjust the camera
lens upward until the MicroSD slot is revealed, then insert the MicroSD card into the slot
(the side with contact points must be facing down).
Note: Please turn o the IMILAB C20's power supply before inserting or removing the
MicroSD card. Please use a genuine Micro SD card manufactured by a qualified supplier,
with a reading/writing speed of no less than U1/Class 10. (Maximum support capacity
is 64 GB)
Reset
MicroSD
Reset

Restore Factory Settings

Press and hold the reset hole with fine needle, then you can hear the "reset succeed"
voice.
Data stored on the MicroSD card is not deleted.
EN-05