Publicidad
Operation Instruction
1. Switch the Power/Speed button to position 1 or 2, the
indicator will flicker, and heating will start automatically.
2. When the indicator stops flickering, press the Start/Stop
button to start loading. Load filament into the filament hole till
it comes out from the nozzle. Press again to stop.
3. Press and hold the Eject/Temperature button once to adjust to
high temperature of the 3dPen. Indicator will turn red. Press
and hold the Eject/Temperature button again to lower
temperature. Indicator will turn green.
4. Click the Eject/Temperature button once to remove filament.
The removal process will last 10 seconds. Stop removal
process by pressing the button during the process.
5. Switch the Power/Speed button to position 0 to power off the
3dPen, the filament will be removed automatically after
powered off.
Note: after 5 minutes without operation, device will be
powered off automatically.
6. When the indicator quickly flickers, charge the device (Use
the adapter with an output of 5V 1A or 5V 2A).
Note: Under powered off mode, the indicator will turn red
consistently during recharging, and it will turn green after fully
charged; Under power on mode, the indicator will quickly
flicker for three times to indicate that charging has started
after plugging in the USB cable, after that the light will
indicate its working status again. When using while charging,
please use 5V 2A power adapter.
EN
WARNING
- This device is suitable for children over 6 years old and
above.
- DO NOT PULL the filament from the rear. To remove, click the
eject button to reverse the filament. Failing to do so will cause
the device to get stuck and malfunction.
- DO NOT REINSERT a filament after removing. You must snipe
the filament before reinserting into myFirst 3dPen.
- DO NOT reuse expanded filaments.
- DO NOT use filaments offered by unapproved manufacturers.
Our filaments are specially formulated to be low heat and
designed specifically for myFirst 3dPen.
Troubleshooting
Please follow the below instruction in case of any defect.
Default
Battery is fully used up
The heating indicator
cannot be powered on
Motherboard defective
Nozzle blocked
No heat
No filament coming out
Gear slips
from nozzle
Failed to load filament
Motherboard defective
No heat
Heating part defective
1
Reason
Solution
Charge device
Repair or replace the motherboard
Replace the nozzle set
Replace the nozzle set or check
the motherboard
Back wire, clean gear, cut off the
damaged supplies
Eject filament and cut the end of
filament properly
Repair or replace the motherboard
Replace the nozzle set
Publicidad
