Descargar Imprimir esta página

Tip-Over Switch - Pelonis NTY15-16LA Manual Del Propietário

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTION
Check before turning on the machine
1. Check if the power wire is under good condition.
2. The product adopts 120V AC power supply, before use, please confirm if
the rated current of the power socket meets the local requirements with safe
grounding device, otherwise, please replace it with the qualified socket.
Put the machine on the flat place
Uneven place may possibly cause the turnover switch at abnormal position, then
the heater can't work after turning on, therefore, please put the heater on the flat
place, at least the surface below the base of the heater must be flat.
Temperature Control Knob
Insert the plug into the power socket, then turn the Temperature Control knob
clockwise, when hearing the "poop" sound (it means the temperature controller is
on), adjust the Temperature Control knob to the desired temperature level.
Power Selection Knob
Turn the Power selection knob to select between 4 functions: Low 900W(LOW),
High 1500W(HIGH), Low 900W Osc (LOW OSCILLATION), High 1500W Osc
(HIGH OSCILLATION).
Turn off the Heater
A. Turn the Power selection knob to OFF position.
B. Turn the Temperature Control knob anticlockwise to the initial position.
C. Remove the power plug, store the heater after the entire machine has become
cool.
Safety Protection
1.Overheat protection: When the temperature in the heater is too high due to
abnormality in the use environment or improper use, the thermostat device can
automatically cut off the power and the heater stops working,then unplug the
heater. After the whole heater is cooling, plug the unit in again and operate
normally.
2.Inversion protection: When the whole heater is inverted, the safety system will
automatically cut off the power, and return to the work state before inversion after
the body is placed upright.

Tip-over switch

As a safety measure, the unit will shut off automatically if it is
knocked over. Should this occur, simply turn the heater off and stand it back up
to a regular upright posit ion, then switch it back on.
3

Publicidad

loading