Shark AI360 ROBOT Manual De Instrucciones página 32

USING THE SHARK AI 360 ROBOT
AI 360 LASER NAVIGATION
After setup is complete, your robot will conduct an
Explore Run to create an initial map of your home.
The robot will travel from room to room to identify
walls, furniture, and other obstacles as it cleans.
This run will take less time than a full cleaning, as it
doesn't cover the entire floor.
MANUAL CLEANING MODE
To manually start a cleaning cycle, press the CLEAN button on the robot or on the mobile app. To
immediately send the robot back to the base, press the DOCK button.
ULTRACLEAN MODE
To start using UltraClean Mode, select a specific room, high-traffic zone, or spot in the SharkClean® app
home map screen. Your robot will clean this targeted area on demand with multi-directional cleaning
coverage.
NOTE: Be sure to charge the robot completely before its first cleaning so that it can explore, map, and clean as much of
your home as possible. It may take up to 6 hours to fully charge your robot.
NOTE: Avoid moving the base. If it is relocated, the robot may not be able to find its way back to the base. If the robot is
relocated while in use, it may not be able to follow its intelligent cleaning path, or find its way back to the base.
sha rkcl e a n.eu
The robot's object detection technology helps it
navigate around obstacles taller than 9cm in height.
Create no-go zones in the app to block off areas
you do not want the robot to enter. You can set up
no-go zones around small objects, or use them to
block off large areas.
MAINTENANCE
EMPTYING THE BASE DUST BIN
The Base Dust Bin holds weeks worth of dust and
debris. Empty the base dust bin when the debris
level approaches the max fill line.
To detach the bin, press the Dust Bin Release
button on top right side of the base, then slide out
the bin.
To empty the bin, hold it over the rubbish bin, then
press the release button with the trash can icon
on the bottom of the bin. The bin lid will open,
releasing dust and debris. Lightly tap the dust bin
against the inside of the bin receptacle to knock off
any remaining debris. Reinstall the bin by sliding it
into the slot in the base until it clicks into place.
s ha rkc lea n.eu