Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
Scope of functions
•
Highest safety level CAT IV 1,000 V
•
Voltage display up to 1,000 V AC /
1,500 V DC
•
Polarity display
•
Integrated measuring point
illumination
•
Auto power on/off
Device parts
1
4 mm test tip adaptor (screw-on)
Test tip L2+
2
3
Measuring point illumination
4
Acoustic and visual warning of
dangerous voltage (> 50 V AC / >
120 V DC)
Visual flow and diode test
5
6
Rotation field test left/right
7
Illuminated LC display with voltage,
polarity and battery level indication
Symbols on your device
Rear of the device (nameplate)
Uninterrupted double or reinforced insulation as per Category II EN 61140.
Protection against electric shock.
The device is certified by TÜV Rheinland and carries the "Geprüfte Sicherheit"
(tested safety) seal of quality according to German law.
Device suitable for use on live parts.
Highest safety level. Applies to test and measurement circuits that are
CAT IV
connected to the source of the low voltage power system.
The device complies with European specifications.
Do not dispose of the device or accessories with general waste (see section on
„Disposal" on page 13).
LED display
An audible signal is issued when flow is detected, in case of dangerous voltage
(> 50 V AC / > 120 V DC) and if voltage is detected during the single-pole phase
test.
The ELV LED lights up in case of dangerous voltage (> 50 V AC / > 120 V DC)
and if voltage is detected during the single-pole phase test.
Even when the batteries are empty, the device indicates dangerous voltage by
lighting up the ELV LED.
Illuminated when flow detected (up to approx. 500 kΩ) (see section on „Flow/
diodes test" on page 12).
LED R is illuminated in case of right rotation. LED L is illuminated in case of left
rotation (see section on „Rotation field test" on page 12).
Indicates the voltage polarity as follows:
12
+
—
AC: LED + and -12 V light up
+ DC: LED +12 V light up
- DC: LED -12 V lights up and "-" appears on the LC display
(see section on „Voltage test" on page 12)
Shows the measured voltage. In case of a 230 V socket, for example, the LEDs
50
24
are illuminated up to 230. The following voltages can be displayed by the LEDs:
12, 24, 50, 120, 230, 400, 690, 1,000 V.
LC display
Symbol lights up when the battery is low.
Shows the measured value.
0000
The data hold function is activated.
HOLD
V
Symbol lights up if voltage is measured.
9
•
LED display and additional
illuminated LC display
•
Single-pole phase test
•
Rotation field test
•
Acoustic and visual flow/diode test
8
Button [measuring point illumination
]
9
Battery compartment
2x battery 1.5 V AAA
10
11
Battery compartment lid with
crosshead screw (PH1)
Dust and splash water protected
12
housing (protection class IP64)
rubberised gripping surfaces
13
LED display
Test tip L1-
14
Publicidad
