Descargar Imprimir esta página

yeep.me 100s ROLAND GARROS Manual página 19

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 47
Before each use, carefully check:
EN
• That the handles are fully tightened.
• That the wheels are functioning properly by lifting the device and running the
wheels idle.
• The column, the steering tube, nothing must prevent it from turning. The entire
steering system must be correctly adjusted and all connecting elements and screws
tightened and in good condition.
• Check the tightness of the screws, the front and rear wheels, shock absorbers, and
bonnet, and tighten again if necessary. These adjustments may be needed because of
vibrations caused by using the device.
• Tyre wear. Tyre pressure if the unit is equipped with air wheels, and inflate as soon
as is necessary using a bicycle pump or similar.
• The brakes, drum linings, brake pads, foot brake, depending on the unit. If the unit is
equipped with mechanical brakes (disc, drum, foot), ensure they are not rubbing due
to cable tension or exhibiting any other problems, as this may cause the unit to slow
down and prevent it from operating normally. Overheating may impact the brake's
efficiency.
• Check that the electric brake is functioning properly if the unit is equipped with one.
If after adjusting you notice looseness that may affect your ability to drive safely, or
if an unusual noise appears, or a lack of fluidity is apparent, stop using the unit and
contact your dealer for more information or care. If the product, a component, or the
battery are worn out, please contact an authorised service centre to repair or recycle
your product.
PERIOD MAINTENANCE AND CHECKS:
CHARGER
Ensure that the charger cord is not damaged and that the wires are not
exposed to avoid short circuits. The input and output sockets must not be
damaged or deformed.
When using the battery charger, it is important to follow the instructions on the label.
WARNING: Only use the charger supplied with the product.
BRAKES
Before each use, check that the brakes are in perfect working order. Check the
brakes regularly to prevent accidents due to brake malfunction.
The brake lever (depending on the model) must not come into contact with the
handlebars and the cables must not be bent at a sharp angle so that the cables
slide with minimum friction. Damaged, frayed or rusty cables must be replaced
immediately.
CAUTION: The surface of the brakes can become extremely hot during and after
operation. You may suffer burns if you come into contact with these hot surfaces.
CAUTION: In rainy or wet weather, braking distances are extended.
19

Publicidad

loading