Cleaning And Maintenance - Taurus V302MT Instrucciones De Uso

4 Once the time is selected, the countdown starts immediately. After 5 seconds the indicator
returns to showing the power indicator. A red dot appears next to it to show that area is using the
timer (except for model V302MT).
5 If you need to check or modify the time, repeat steps 1 and 2
6 When the countdown ends, the corresponding cooking area switches off. The other areas, if
they are switched on, will continue to operate normally.
7 If no area is selected in step 1, the timer will not switch off any cooking area when the timer
finishes. In this case, the timer only functions as a time reminder.
CHILD LOCK FUNCTION (EXCEPT V302MT)
The controls can be locked to prevent accidental use of the hob. (except V302MT)
When the controls are locked, all controls except the Off control are disabled.
Press the child lock button for 3 seconds. The time indicator will show "Lo"
To unlock the controls, press and hold the child lock button until the controls are unlocked.
STOP&GO FUNCTION (EXCEPT V302MT)
The pause function can be used at any time during cooking. It allows the hob to be stopped and
then started again without losing the settings it had previously.
While the hob is operating, press the Stop&Go button The cooking area indicator will display "II"
To cancel the pause function, press the Stop&Go button again, the cooking areas will return to
their previous power settings.
DOUBLE RING FUNCTION (ONLY V6031S)
While the left cooking area is operating, press the flexible area selection control.
This will activate the outer ring
KEEP WARM FUNCTION (EXCEPT V302MT)
By touching the Keep Warm mode selection button
low power setting (A, b or
cooking area panel, depending on whether one or two rings are being used.

CLEANING AND MAINTENANCE

Before carrying out any maintenance or cleaning tasks, disconnect the appliance from the mains
and make sure that it is completely cold.
Avoid scratching the hob with abrasives, the bottom of the cookware, etc., as this will eventually
leave marks on the glass.
Clean the surface of the appliance regularly to prevent a build-up of residues.
The hob should be cleaned after use.
Different types of dirt can be cleaned as follows:
Type of dirt
Limescale
Burnt stains
Light stains
Melted plastic or
sugar
Cleaning method
Apply white vinegar to the surface, then wash it
off using a soft cloth.
Clean off with a damp cloth and then dry with a
soft cloth.
Clean off with a damp cloth and then dry with a
soft cloth.
Use a suitable vitro-ceramic scraper to remove
any marks.
the selected area heats up at the selected
c). One or two lines appear on the left-hand
Special ceramic hob
cleaning liquid
Special ceramic hob
cleaning liquid
Sponge
Special ceramic hob
cleaning liquid
Cleaning materials