Publicidad
Idiomas disponibles
Idiomas disponibles
English
Note: A fully charged battery will loose
about 2% of its charge per month during
storage.
Before use
9.2
The battery must be charged before using it
for the first time.
Removing the battery from the
9.3
machine
(See Fig. A).
• Push the battery release button (12) and
pull the battery (13) out of the machine.
WARNING: Do not try to remove the battery
without pressing the battery release button.
The drill or battery could be damaged.
Inserting the battery into the machine
9.4
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
• Insert the battery (13) into the machine,
push the battery further forward until it
clicks into place.
Note: Make sure the battery and machine
are lined up correctly. If the battery does not
slide onto the machine easily, don't force it.
Instead, remove the battery; check the top
of battery and the machine slot are clean
and undamaged and that the contacts are
not bent.
Charging the Battery
9.5
WARNING: Failure to follow the correct
procedure when charging batteries will
result in permanent damage.
a. Plug the charger plug into an electrical
outlet. The green LED indicator (18) on
the charger (19) will lighten up.
b. Slide a battery (13) onto the battery
charger (19).
c. Once charging commences, the red
LED (17) will illuminate.
d. When the battery is fully charged, the
green LED (18) will illuminate.
Note: Make sure the battery and battery
charger are lined up correctly. If the battery
does not slide onto the battery charger
easily, don't force it. Instead, remove the
battery; check the top of battery and the
battery charger slot are clean and undam-
aged and that the contacts are not bent.
10
7064197-Nexxsaw-12V-Ma-2203-29.indb 10
7064197-Nexxsaw-12V-Ma-2203-29.indb 10
Battery Charge Level
9.6
The battery has a built-in charge indicator.
Pressing on the button (11) to the right will
indicate the charge level.
IMPORTANT: When a low charge level is
indicated be aware the tool may stop oper-
ating while using the tool. In some
instances this may be dangerous. It is rec-
ommended to always ensure the battery
pack has a good charge level.
Notes about Battery Charging
9.7
• Let a hot battery cool down before charg-
ing it.
• The battery should be charged at ambi-
ent temperatures between 10 °C and
40 °C (ideally around 20 °C).
• After charging, allow 15 minutes for the
battery to cool before use.
• Ensure that the charger is disconnected
from the mains supply after use, and is
stored correctly.
• Do not leave batteries on charge for
extended periods and never store batter-
ies on charge.
• The battery charger monitors battery
temperature and voltage while charging.
Remove the battery once charging has
been completed to maximise charge
cycles of the battery and not waste
power.
• Do not store Lithium-Ion battery packs in
a discharged state long term. This can
damage the Lithium-Ion cells. For long-
term storage, store batteries in a high
charge state disconnected from the
power tool.
• The capacity of batteries will reduce over
time. After 100 charge cycles, the bat-
tery's operation time and the maximum
torque performance of the tool will
slightly reduce. This decline will continue
until the battery has minimal capacity
after 500 charge cycles. This is normal
and not a fault with the battery pack.
09-05-2022 12:38
09-05-2022 12:38
Publicidad
