Inserting The Battery - SOMFY 1875100 Manual

Inserting the battery

Insert the supplied CR2450 lithium battery, with the + on top.
Keep the product open so that you can mount it on the wall.
If you will not be mounting the detector on the wall immediately, remove
the battery from the open detector to prevent the battery from draining.
Assigning the opening detector to a detection zone
(PROTEXIAL io only)
Open the product by unscrewing the side screw.
For this product, the monitored zone and the trigger
mode are defined using switches located inside the
product. They must be configured when the product is
installed.
Select
zone – trigger mode
AT - delayed triggering
(default)
A - immediate triggering
B - immediate triggering
C - immediate triggering
In case 2 sliding windows are protected by a single detector, the selected trigger mode will be identical for both
the windows.
Storing in the central unit/phone dialer
Activating the central unit/phone dialer storage mode:
If your system is already operational and the central unit/phone dialer is already installed, and you want to
add this detector, you can enter storage mode in 3 ways:
either from a computer by going to the "Device list" screen in the installer menu and pressing
J
necessary, refer to the alarm system installation manual);
or from the LCD keypad by entering OFF + user code, then
J
+ OK (if necessary, refer to the alarm system installation manual) ;
or using a previously stored remote control, by pressing OFF until the indicator goes out. You will hear a
J
Beep!
on the central unit when you start pressing and then a second
indicator goes out.
Storing the opening detector in the central unit/telephone dialer:
Reminder: maximum of 50 devices per central unit/phone dialer.
Press the key on the front of the opening detector: the red indicator flashes and goes off + you will hear a
Beep!
on the central unit/telephone dialer: the opening detector is stored in the
central unit/phone dialer.
The opening detector is represented by the pictogram
devices" on the computer interface.
2
Position of
switches
Telephone transmission of an alarm message.
Triggering of the outdoor siren with flash after 10 seconds.
Telephone transmission of an alarm message.
in the "List of system
Copyright © 2020 Somfy Activités SA. All rights reserved.
What happens in the event of intrusion
(in partly or fully armed mode)
Delayed triggering of sirens
(after the entry delay).
+
Immediate triggering of the indoor siren.
+
+
+ installer code + 753 (Open memory menu)
Beep!
on the central unit when the
(if
Opening